I just finished installing my wheels after putting on some PR4s.
Thanks for the posts and instructions Peoples1234.
The rearwheel was straight forward and when I torqued the nut to 130 lbs, the retainer clip lined up perfectly.
I don't have an alignment tool for the front, but everything seemed to go together ok.
The instructions state to line up the hole in the bolt. Looking up in the fork I can see the adj bolts but the only holes in my axle bolt are the 2 notches in the end. What holes are they refering to?
Also, I torqued the nut to the proper torque, 63NM but there are still 2-3 threads showing on the nut as if the bolt should pull through the forks further but there is no gap on the wheel bushings so it can't go any further.
Am I doing something wrong or is it normal to have the threads showing on the nut?
Thanks
Thanks for the posts and instructions Peoples1234.
The rearwheel was straight forward and when I torqued the nut to 130 lbs, the retainer clip lined up perfectly.
I don't have an alignment tool for the front, but everything seemed to go together ok.
The instructions state to line up the hole in the bolt. Looking up in the fork I can see the adj bolts but the only holes in my axle bolt are the 2 notches in the end. What holes are they refering to?
Also, I torqued the nut to the proper torque, 63NM but there are still 2-3 threads showing on the nut as if the bolt should pull through the forks further but there is no gap on the wheel bushings so it can't go any further.
Am I doing something wrong or is it normal to have the threads showing on the nut?
Thanks
Last edited:
