I've got the Melcodiag from Jpdiag hooked up and recognizing the bike, but can't make any TPS reset or see error codes. Do I have the correct program for a 2014 Hyper? It seems decent, but the guy is in France and doing it for free, so response for help is sporadic. It seems to be incomplete for my ECU.
Has anyone got the Melcodiag to work for '14 HM?
- Thread starter Ducamok
- Start date
Joined Dec 2019
69 Posts | 11+
Brasília - DF - Brazil
I have tried also. 2014 HYM SP. It just connected to the bike and read the odometer and few other stuff. It didn’t reset the oil change indicator and TPS reset seems to not have any effect. I think it just doesn’t work with the marelli ecu in our bikes. It did work on my brother’s monster 796 Siemens ecu though.
Joined Dec 2019
69 Posts | 11+
Brasília - DF - Brazil
![Melco[1].jpg](https://cdn.imagearchive.com/ducatihyper/data/attachments/3/3249-1eebb2526bc628154c3e8f2d3f8099af.jpg "Melco[1].jpg")
![Melco[2].jpg](https://cdn.imagearchive.com/ducatihyper/data/attachments/3/3250-6358d629a17b07b81bfd36d33719b0a2.jpg "Melco[2].jpg")
I'm messing with this again. I can't get it to read error codes. It recognizes the ELM but not the ECU.
I should be getting error codes because the bike dies while I'm riding along. I coast to a stop on the side of the road, turn the ignition off and on and it starts right back up.
Joined Dec 2019
69 Posts | 11+
Brasília - DF - Brazil
There’s something wrong. The VIN doesn’t appear on the screen. Are you using the right connector? The right boud rate?
using melcodiag 2.0.2.0 on my 2014 hyper works great reset desmo and service + reads fault codes. odb11 must have correct chip or will not work.
