For Sale 14mm handlebar spacers

kuksul08 · May 26, 2016

I am selling a pair of 14mm handlebar spacers with new nuts and bolts. This is 5-6mm less than the stock setup.

Decided to try a shorter height and didn't want these to go to waste! Asking $35 shipped in the US. Thank you

BelloStrada · May 27, 2016

I'm definitely interested! But if I read your post correctly, you went to an even shorter bar height?

kuksul08 · May 28, 2016

BelloStrada said:
I'm definitely interested! But if I read your post correctly, you went to an even shorter bar height?

Yeah, so I have the SP model which doesn't come with a spacer at all. I wanted to try out something like the Hyperstrada's 20mm spacers, but not as high. So I made these 14mm spacers. Turns out I actually like the stock height or thereabouts (no spacer) or maybe I am just used to that, so I am selling these rather than shaving them down since they're perfectly fine.

BelloStrada · May 31, 2016

What's involved as far as the install goes...any crazy access issues requiring disassembly of half the front end?

kuksul08 · May 31, 2016

BelloStrada said:
What's involved as far as the install goes...any crazy access issues requiring disassembly of half the front end?

Not at all, just removing the 4 screws on the handlebar, then the 2 bolts holding the risers on. I used a ratchet with an extension from the bottom side, and my friend to hold the bolt from the top to hold it from spinning.

krolinked · Jun 9, 2016

Do the threads protrude pas the nut or is the bolts the exact length?

kuksul08 · Jun 9, 2016

krolinked said:
Do the threads protrude pas the nut or is the bolts the exact length?

They stick past about 3mm to fully engage the nut. No clearance issues whatsoever.

Tron · Jun 9, 2016

What are the torque specs for the 4 handlebar screws, and the 2 riser nuts? I'm assuming they are the same for the 821 as the 939, but I don't have the 939 service manual yet.

Reason I'm asking is because I'm thinking of removing my 20mm risers.

Thanks in advance

flvraptor · Jun 10, 2016

The risers screws should be torqued to 45 Nm Â± 5%, following a 1-2-1 sequence.

The top cap/plate screws should be torqued to 25 Nm Â± 5%, following a cross pattern.

kuksul08 · Jun 10, 2016

flvraptor said:
The risers screws should be torqued to 45 Nm Â± 5%, following a 1-2-1 sequence.

The top cap/plate screws should be torqued to 25 Nm Â± 5%, following a cross pattern.

The top cap is machined such that one side gets tightened first then the other side clamps down. Tighten the side with the arrows first (toward seat), then the other side (dash side).

krolinked · Jun 20, 2016

Still avaliable? whats your paypapl if so? thanks

kuksul08 · Jun 20, 2016

Sold!

For Sale 14mm handlebar spacers

Help Support Hypermotard Forum:

kuksul08

Well-Known Member

BelloStrada

Well-Known Member

kuksul08

Well-Known Member

BelloStrada

Well-Known Member

kuksul08

Well-Known Member

krolinked

Well-Known Member

kuksul08

Well-Known Member

Tron

Well-Known Member

flvraptor

Well-Known Member

kuksul08

Well-Known Member

krolinked

Well-Known Member

kuksul08

Well-Known Member

Similar threads

Recent Discussions