MelcoDiag JPdiag questions for Hyperstrada

iahforgaming · Jun 16, 2022

I want to read/clear errors and reset oil/Desmo warning on my Hyperstrada. I am ok with not being able to do TPS. So far I got a Lonelec KL1 module and a re-pinned Fiat 3 pins connector but I am not able to get it working with JPdiag28. With Guzzidiag, I can connect to my Strada using the California 1400 option and got info from the Strada. Is there anyone that got the 3 pins and have perform the procedures mentioned above?

Or should I stop and get a ELM327 v1.4 module and the 4 pins Canbus connector.

According to the JPdiag forum. There were report of the Melcodiag SW being able to reset oil and desmo warning. Can anyone confirm? By the way, I am assuming the port shown in the picture is the Canbus diagnostic port.

Thanks.

hyperbruno · Jun 17, 2022

I could reset oil and desmo service with the Melcodiag connected to the 4 pin port. That’s all. Until now Melcodiag doesn’t support resetting the TPS for the 7sm ECU.
Using the right FTDI chipset is a must for this procedure. I use the one from Lonelec.
Download the latest version of Melcodiag as there was some updates lately.
Br
Bruno

iahforgaming · Jun 17, 2022

Thanks Bruno. I guess I need to get a new ELM327 module with the FTDI chip and a 4 pins cable. Unfortunately Lonelec is currently out of the MelcoDiag cable kit. Just being able to reset the oil and desmo service is good for me.

MelcoDiag JPdiag questions for Hyperstrada

Help Support Hypermotard Forum:

iahforgaming

Active Member

hyperbruno

Well-Known Member

iahforgaming

Active Member

Similar threads

Recent Discussions